Sleipner SRV210 Vertical Retractable bow/stern thruster 24V (SRV210/250TC)

The SRV210 is a sturdy retractable thruster suitable for cruiser-racers or flat-bottomed boats between 17-24m. With its quick deployment and 210-250 kgs of thrust, you get a thruster installation you can rely on year after year.

POWER SUPPLY

Powered by direct current.

FLEXIBLE COUPLING

Flexible coupling protects the product’s driveline by compensating for misalignment between the shafts of the electric motor and gearleg.

ANALOG

Sleipner analog signal cables with Plug & Play connectors are color-coded to match the wiring diagrams with high-quality connectors to ensure a correct installation.

OVERHEAT PROTECTION

Automatic detection of overheating of internal components. When an unsafe temperature is detected, the unit is automatically shut off to prevent overheating.

GALVANIC SEPARATION

Immersed parts exposed to seawater are galvanic isolated from the onboard electrical system, eliminating stray currents.

SEALED DRIVE LUBRICATION

The thruster gearleg is pre-filled for lifetime lubrication and sealed using a long-time mechanical seal with ceramic and carbon surfaces for ultimate security against water intrusion.

TWIN COUNTER-ROTATING PROPELLERS

Two counter-rotating propellers offer the most thrust at a good performance ratio in a minimal tunnel diameter. This system is used in our larger thrusters for maximum power. Our twin-counter thruster range is the favorite among leading boatbuilders in high-end yachts.

Q-PROP™

The Q-PROP™ has measured noise reductions of up to 75% in controlled environments. The five-bladed skew propeller reduces noise levels while maintaining exceptional efficiency. Some thruster models even see an increase in thrust power.

• The expected noise reduction in average installations: 20-40%
• Upgrade kits are available for most Sleipner thruster models with special adaptors

INTELLIGENT POWER CONTROL

Sleipner's patented intelligent power control provides a minimal delay between drive directions to reduce wear of the mechanical parts while monitoring solenoid functions. In the case of a solenoid lock-in, the thruster will automatically stop without extra user action or controlling the main switch.

Dimensions:

• (H) Height: 389mm / 15.31in
• (+H) Additional Height: 211mm / 8.31in
• (L) Length: 688mm / 27.09in
• (W) Width: 480mm / 18.90in
• (ID) Internal Diameter: 250mm / 9.84in
• (RD) Retract Depth: 374mm / 14.72in
• (RW) Retract Width: 348mm / 13.7in
• (MW) Mould Width: 420mm / 16.54in
• (MH) Mould Height: 93mm / 3.66in